Send To A Friend Tips for Operating the INT 732
http://www.youtube.com/watch?v=Wd6Hy4x5XQE Type 0 operation
http://www.youtube.com/watch?v=Hfbv-fC5ADc Type 1 Operation
http://www.youtube.com/watch?v=yrLLZN2Vh0w Development of a profile part 1
1. Keep all ramp rate at 100. (There is no need to adjust the ramp rate unless necessary).
2. Segments 1 to 3 controls the bottom heater. Segments 4 to 9 control the top heater. which means whatever is the set temperature at segment 3 the system would stabilize the bottom temperature at that set temperature for the rest of the duration.
3. The option of using "1" internal sensor or "0" external sensor as control points is optional. Our recommendation is to keep it at "0" = external sensors.
4. Save the profile after adjusting.
Set Temperature
Set Time
Set Ramp
Segment
starting temperature 80
1
100
30
100
2
150
30
100
3
180
30
100
4
180
30
100
5
200
30
100
6
210
30
100
7
220
30
100
8
230
30
100
9
230
10
100
http://www.youtube.com/watch?v=mlqTUIF5GoY Development of a profile part 2
http://www.youtube.com/watch?v=3xH1cciRQc4 Development of a profile part 3
Guide for using the temperature hold method:
Sample Profile:
